The Morso 1446 is a really nice looking stove, very far removed from the original Squirrel, almost so much so as to make it unrecognisable. Like other Morso convector stoves the 1446 has sides which extend right down to the floor to form the legs. The sides are squared off and the straight surfaces and tight lines gives a timeless design. All in all I think that Morso have done a really nice job of redesigning this stove, it is elegant, understated and very simple. Of course like the other Morso stoves the 1446 burns very well, is efficient, and easy to control. With a heat output of 4Kw the Morso 1446 is suited to the smaller room.
And a quick note about the flue pipe in the picture - here you can see that the flue pipe from the Morso 1446 stove curves round by 90 degrees and then runs horizontally into the wall. In the UK you are not allowed to run the flue pipe from your Morso 1446 stove like this, you can go 45 degrees off vertical at most. We do carry a swept 45 degree bend which we can supply with this stove to achieve something similar yet legal.
|FLUE DIAMETER||125 MM|
|NOMINAL HEAT OUTPUT||4 kW|
|BACK OF STOVE TO CENTRE OF TOP FLUE||135 MM|
|FLUE OUTLET||Top or rear|
|HEIGHT TO CENTRE REAR FLUE||606 MM|
|MADE OF||Cast Iron|
|DEFRA APPROVED FOR SMOKE CONTROL AREAS||Yes|
|MAX LOG LENGTH||280 MM|
Ring Stovesonline on 0845 226 5754 | 01803 712316 | 01580 201385 When you ring Stovesonline you will never be held in a queue, given options or made to listen to music. If we are too busy to answer immediately then simply leave your name and number on the answer phone and we will ring you straight back.
Or write to us via our enquiry system
Would you like us to design & spec. your chimney or liner system? Just use our
Flue Design Service
At Stovesonline we can assist you at every step of the way from helping to choose the right stove, our flue designers can design your chimney system and installation, we arrange for everything to be delivered to you, and of course we can put you in contact with a local experienced installer.